Index	Norm			Testing method
	TEPLEX 35 - 250	TEPLEX 35 ECONOM	TEPLEX 45
1. Density, kg/m3	28,0 - 38,0	28,0 - 38,0	34,0 - 45,0	All-Union standard 17177-94
2. Compressive strength at 10% linear deformation, MPa, minimum	0,25	0,25	0,50	All-Union standard 17177-94
3. Cross-breaking strength, MPa	0,4 - 1,0	0,4 - 1,0	0,4 - 0,7	All-Union standard 17177-94
4. Water absorption, volume %, up to:				All-Union standard 17177-94
a) within 24 hours	0,2	0,2	0,2
b) within 30 days	0,4	0,4	0,4
5. Dry heat conductivity at temperature (25+5˚C) Kcal/mh˚C	0,028	0,028	0,030	All-Union standard 7076-99
6. Vapor transmission rate mg/m.h.Pa	0,018	0,018	0,015	All-Union standard 25898-83
7. Capillarity	0	0	0
8. Linear thermal expansion coefficient	80*10-6
9. Elasticity modulus, MPa	12	12	12
10. Fire resistance category, group		B4	B4	Construction norms and regulations 21.01.1997

Chemical Inertness

Low chemical inertness to the following  substances:  

• Benzene hydrocarbons (benzol, toluene, xylene)
• Aldehydes (formaldehyde, formalin)
• Ketones (acetone, methyl ethyl ketone)
• Simple and compound ethers (diethyl ether, ethyl and methyl acetate-based solvents)
• Petrol, kerosene oil, fuel oil
• Coal tar
• Polyester resin (epoxy hardeners)
• Oil-base paints

High chemical inertness to the following substances:  

• Acids (organic and mineral)
• Salt solutions
• Caustics
• Chloride lime
• Spirits and spirit coloring agents
• Water and water-based inks
• Ammonia, carbon dioxide, oxygen, acetylene, propane, butane
• Freons
• Cements (cement mortars and concretes)
• Animal and plant oils, paraffin wax

Storage conditions

·        Open air storage required

·        Protect from direct sunlight, however, in packed condition material is totally UV-protected.

Service conditions

Temperature range: from -50 to +75C

Product range

Trademark: TEPLEX 35 - 250, TEPLEX 35 ECONOM, TEPLEX 45 
Thickness range: from 5 to 120 mm
Board size*: 600*1200 mm (W*L) (machine-edged board); 640*1240 mm (W*L) (straight edged board)
Edge type: straight, shiplap
Board surface: even, embossed and "plaster"

____________________
*Boards yield of a bigger length is possible (up to 12m)